SICK WSE26P Instrucciones De Uso página 33

7 Commissioning
7.1 Alignment
7.2 Check the application conditions
8020358.1GI9/2022-07-13 | SICK
Subject to change without notice
WSO26P, WSO26G: Align the sender with the receiver. Select the position so that the
red emitted light beam hits the receiver. Tip: Use white paper or a reflector as an
alignment aid. The sender must have a clear view of the receiver, with no object in
the path of the beam [see figure
screens) of the sensors are completely clear.
WSO26I: Align the sender with the receiver. Select the position so that the infrared light
(not visible) hits the receiver. The correct alignment can only be detected via the LEDs.
See figure 5 and table 5. The sender must have a clear view of the receiver, with no
object in the path of the beam. You must ensure that the optical openings (front screen)
of the sensors are completely clear.
Figure 5: Alignment 1
WEO
WSO
WEO
Figure 6: Alignment 2
WSE26 are through-beam photoelectric sensors that can be used at shorter distances,
in particular due to the large sensing range or the very high operating reserve.
Note application conditions: Adjust distance between sender and receiver with the
associated diagram [see table
If several through-beam photoelectric sensors which are installed next to one another
are to be used, we recommend swapping the sender/receiver arrangement at every
second through-beam photoelectric sensor and ensuring that there is sufficient dis‐
tance between the through-beam photoelectric sensors. By doing this, mutual interfer‐
ence can be prevented [see figure
OPERATING INSTRUCTIONS
5]. You must ensure that the optical openings (front
17] (x = sensing range, y = operating reserve).
1].
O P E R A T I N G I N S T R U C T I O N S | WSE26
en
33