BirdBike VA00038 Manual Del Usuario página 7

Y-wrench
Install the Handlebar
Use the 5mm end of the tool to remove the hex bolt
from inside the black disc top cap that's sitting on
the protective cardboard tube. The black disc top
cap and cardboard sleeve will not be used during
the assembly, so please set aside along with the box
and other packaging.
After removing the hex bolt, black disc top cap, and
protective cardboard tube, install the handlebar
on top of the steerer tube. Once the handlebar
is installed and lined up properly with the tire and
frame, re-insert the hex bolt through the handlebar
and into the steerer tube.
Use the 5mm end of the tool to gently tighten the
hex bolt into the handlebar so that there's no play
between the fork and frame.
Finally, make sure the handlebar, frame, and front
wheel are still aligned and tighten the two steering
stem screws with the 5mm end of the tool so the
handlebar stays in place.
7