BirdBike VA00038 Manual Del Usuario página 8

3 Install the front wheel
Be sure to remove the plastic front rotor protector from the front
wheel axle before starting this step.
Align the front wheel axle so that it's inside of the fork slots on both
sides. The side with the brake rotor should be aligned so that it fits
inside the front disc brake.
Once the fork slots are sitting on both sides of the axle, install
washers at both ends and tighten up the cap nuts on the outside
using the 15mm end of the wrench.
After installing the front wheel,
extend the kickstand for better
stability and easier assembly
during the next steps.
A - F R A M E
Cap Nut Wrench
and Washer