Thermador Professional Serie Guia De Instalacion página 23

Installing the filters and grease trays
Turn the fan and lights off.
1.
Remove all plastic from hood pieces.
2.
Insert the grease tray in rear tray. Push the grease tray
3.
in and down inside the grease tray trough. Grease trays
must be in place before installing the filters.
The small grease tray must be installed in the center
‒
of hood.
Install the filters. Start with an outside filter. Grab the
4.
filter by the handle, if applicable, or by the sides. Do not
place fingers inside the filter slats. Slide the filter up,
toward the front of the hood, then push down on top of
the grease tray.
To remove the filters and grease trays, ensure the filters
5.
are cool and grease has congealed. Then proceed in
reverse order of the previous instructions.
6 Installer checklist
Installer checklist
Final check
Installer checklist
Specified clearances maintained to cabinet
surfaces.
Appliance is level.
All packaging material removed.
Proper ground connection.
Owner is aware of location of the main circuit
breaker.
INSTALLER: Write the model number and serial
number in the Use and Care Guide. Leave the Use
and Care Guide and Installation Guide with the
owner of the appliance.
To clean and protect exterior surfaces
Clean the stainless steel surfaces by wiping with a
¡
damp soapy cloth. Rinse with clear water and dry with a
soft cloth to avoid water marks. Remove fingerprints
and smears with mild glass cleaner.
To polish and protect stainless steel, apply a stainless
¡
steel conditioner with a soft cloth. The Thermador
Stainless Steel Conditioner is available for purchase in
the online accessories store (US only)
www.thermador.com/us/accessories. Order part number
00576697 (spray bottle) or 17002200 (wipes).
Do not use conditioner on non-steel surfaces, logos,
¡
control markings, labels, black or smudge-proof
stainless steel, and appliance interiors.
DO NOT allow deposits to remain for long periods of
¡
time.
DO NOT use ordinary steel wool or steel brushes. Small
¡
bits of steel may adhere to the surface causing rust.
DO NOT allow salt solutions, disinfectants, bleaches or
¡
cleaning compounds to remain in contact with stainless
steel for extended periods. Many of these compounds
contain chemicals which could prove harmful. Rinse
with water after exposure and wipe dry with a clean
cloth.
Troubleshooting
See the Use and Care Guide for troubleshooting
information.
Refer to the Limited Product Warranty in the Use and Care
Guide. Please be prepared with the information printed on
your product data rating plate when calling.
7 Customer Service Customer Service
With any warranty repair, we will make sure your
Customer Service
appliance is repaired by an authorized service provider
using genuine replacement parts. We use only genuine
replacement parts for all repairs.
Detailed information on the warranty period and terms of
warranty can be found in the Statement of Limited Product
Warranty, from your retailer, or on our website.
If you contact Customer Service, you will need the model
number (E-Nr.) and the production number (FD) of your
appliance.
The LED light sources are available as a spare part and
should only be replaced by an authorized service provider.
USA:
1-800-735-4328
www.thermador.com/support
www.thermador.com/us/accessories
CA:
1-800-735-4328
Installer checklist en-us
23