Publicidad
Idiomas disponibles
Idiomas disponibles
34. Fasten the Return Bottom Panel (J) to the Return Support Frame (Z) with ten 32 mm Screws (12).
35. Now, go back and securely tighten all the screws and bolts. Make sure all the parts are tight and there
are no gaps between the parts. This will keep the unit square.
36. Feed the wire of Power Center (D1) through the cutout on the Desk Back Panel (C) and Desk Bottm
Panel (B). Snugly fit the Power Center (D1) into place and fasten with two 12 mm Screws (13). Make
sure the wire is not pinched.
Assembly Instructions
Z
A
C
21
12
D1
13
13
Publicidad
