Publicidad
Idiomas disponibles
Idiomas disponibles
37. Find the optimal place to mount two Cable Wheels (C1) onto the Panels (C, G and K). Using a pencil to
mark the two mounting holes on each panel (C, G and K) at the desired location, using the Cable Wheel
(C1) as a template.
38. With an electric drill (not included) on its low setting, drill 3 mm diameter holes with a depth of 10 mm
on the marked points.
39. Fasten the two Cable Wheels (C1) to the pilot holes with four 12 mm Screws (10). The cable wheels
allow you to organize, route and separate your component cords and cables to minimize tangling and
signal interference.
40. Insert the assembled drawers into the frames. Extend the Ball Bearing Slide Tracks on the panels all the
way forward (including ball bearing cart). Then align the Slide Runners on the assembled drawers with
the Slide Tracks and push the drawer carefully inside until it stops.
NOTE: If the drawer does not go in smoothly, please take it out and repeat the step. If you need to
remove the drawer, please pull the drawer all the way out, then simultaneously pushes the plastic release
lever of the ball bearing slides up on one side and down on the other side, and then pull it completely out.
41. Position the Pencil Box (U) inside either drawer for better access.
Assembly Instructions
Route
Shorten
K
A
U
O
O
C
G
Ball bearing cart
I
22
C1
10
Drawer Installation
FRONT
FRONT
Ball bearing cart
Publicidad
