Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Make sure the steam release handle and float valve are unobstructed and clean and that the
sealing ring is properly seated.
2.
Insert the inner pot in the cooker base and add water to the "3" mark on the inner pot.
3.
Close the lid. Make sure that the steam release handle is pointing to "Sealing" mark on the lid.
4.
Press the "Steam & Egg" button and press the "-" button to change the time to 2 minutes.
5.
In 5 seconds, your multi cooker will go into the preheating cycle (display showing "00:10"). Within
a few minutes steam will start coming out for a minute or two until the Float Valve pops up and
seals the cooker. Within another minute or two the working pressure will be reached, and the
countdown timer will begin. Once the countdown is finished, your multi cooker will beep and
automatically go into the. "Keep Warm" mode. That's it. The test is complete. Press the "Keep-
Warm/Cancel" button and/or unplug the unit. Once the pot cools down, you can open it and are
ready to try your favourite recipe.
CARE AND MAINTENANCE
Regular care or maintenance is essential in ensuring that this product is safe for use. If any of the
following circumstances take place, please stop using the appliance immediately and contact the
retail store or online merchant. When:
•
Power cord and plug suffer from expansion, deformation, discoloration, damages, etc.
•
A portion of power cord or the plug gets hotter than usual.
•
Electric multi cooker heats abnormally, emitting a burnt smell.
•
When powered on, there are unusual sounds or vibrations. If there is dust or dirt on the plug or
socket, please remove dust or dirt with a dry brush.
CLEANING
CAUTION: please make sure the appliance has cooled down and is unplugged before cleaning.
•
Clean the product after each use. Wipe the black inner housing rim and slot dry with cloth to
prevent rusting on the exterior pot rim.
•
Remove the lid and take out the inner pot, wash them with detergent, rinse with clear water and
then wipe dry with a soft cloth. The stainless-steel inner pot is also dishwasher safe.
•
Use water to clean the lid, including the sealing ring (which can be removed), exhaust valve,
anti-block shield, and wipe them clean with dry soft cloth. Do not take apart the steam release
pipe assembly.
•
Clean the cooker body with clean damp cloth. Do not immerse the cooker into water. Do
not use a wet cloth to clean the pot while the power cord is plugged into the power outlet.
Troubleshooting If you experience any problem with the appliance, please contact the retail
store or online merchant. For technical assistance and product return information. The cases in
the following tables do not always indicate a faulty cooker. Please examine the cooker carefully
before contacting the support for repair.
TROUBLESHOOTING TABLE
No.
Description
1
Unable to close lid.
2
Unable to open lid.
3
The air leakage of pot cover
Cause
The installation of gasket is
not correct.
The ball float valve on splint
is jammed.
The ball float valve doesn't
fall.
The installation of gasket is
not correct.
- 17 -
Solution
Calibrate the position of
the gasket.
Gently poke the valve plate
Use a toothpick to gently
poke the valve
Calibrate the position of
the gasket.
Publicidad
