Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustments
Prior to operating your tiller, carefully read and follow all instructions below.
Perform all adjustments to verify your tiller is operating safely and properly.
Depth Stake & Wheels
The tiller is shipped with the wheels adjusted so that the machine sits level. The
wheels need to be adjusted to meet your tilling needs before operation. This
adjustment is made by removing the clevis pin from the wheel yoke and raising the
wheels to the desired height. See Figure 9.
Wheel Yoke
Cotter
Pin
WARNING
Clevis
Pin
Depth
Stake
Figure 9
ASSEMBLY
Clutch Cable Adjustment
1.
Before operating the tiller the adjustment of the forward clutch cables must
be checked.
2.
Disconnect and ground the spark plug wire against the engine.
3.
Adjust the forward clutch cable by loosening the hex nut. See Figure 10.
Cable Collar
4.
Turn the cable collar section one or two turns to increase or decrease tension
on the cable. See Figure 10.
5.
Retighten the lock nut against the cable collar. See Figure 10.
6.
With the forward tine engagement handle in the neutral — released —
position, pull the starter rope several times. The tines should not turn.
7.
If they turn adjust the forward clutch cable to release tension using the
previous steps in this section.
8.
Check again for correct tension on the cable.
9.
After tilling, if the tines stop moving, re-adjust the cables.
9
Hex Nut
Figure 10
Publicidad
