Create WIND CALM Manual Del Usuario página 11

C O NNECTION S PANE L AS SE MB LY
Connections panel
Attach the connections plate up to the bottom of the fan by inserting the set screw heads
into the key hole slots. Rotate them to place and tighten them to secure the plate.
LE D LIGH T PANE L AND L AMP SH AD E AS SE M B LY
Connect the single-pin plugs of the connections plate with the ones on the LED panel. The
LED panel is magnetized so it will be attached to the connections panel just by placing
them together.
Note: While installing or removing the LED plate, please keep the insulation pads intact
carefully. Turning the set screws over-tightly or fast will damage the insulation pads.
Screw the lamp shade back to the connections plate.
C H ECK THE I NSTALL AT IO N
• Check the correct operation of the ceiling fan, checking that no strange movement or
misalignment is observed in any part of the fan.
• In the event that some kind of hum / vibration can be seen, you can proceed to adjust the
blades with the shooting kit.
• This kit has self-adhesive weights and "u" shaped clips.
• Turn off the ceiling fan.
• You can put the clip in the center of any blade and check if the vibration decreases.
• Turn on the fan and check. If no change is seen, turn off the fan and add another clip to a
different blade or use the adhesive weights.
Single-pin plug
LED panel
WIND CALM
WITH LED LIGHT
Panel screws
E NGLI SH
11