Porsche E-Performance Standhalterung Manual De Instalación página 20

Installation
4. Undo the screws for the side sections (10x) on
both sides of the base frame and push the side
sections evenly into the desired position.
Bear in mind the maximum heights from Step 1.
5. Re-tighten the side section screws (2x10) on
both sides.
20
Fitting the rear panel
2
10x
1. Open the rear panel
lock with the supplied
key.
1
2. Attach the rear panel
to the two stud bolts
in the lower section
3
of the pedestal frame
and swivel into the
catches to secure.
3. Lock the rear panel
with the supplied key.
Fitting the charging dock panel
1. Guide the infrastruc-
2
ture cable for supply-
ing power to the
Universal Charger
through the cut-out
in the panel.
3
2. Attach the panel to
the two stud bolts
1
in the lower section
of the pedestal frame
and swivel into the
catches to secure.
3. Fasten the mounting
panel (with pre-
installed infrastruc-
ture socket) to the
pedestal (M8 screws).