AERMEC RePuro 100 Manual De Uso página 23

RePuro is an innovative counter-flow
heat recovery system which ensures
the correct renewal of air to indoor
environments. Through the use of up
to 90% high efficiency heat exchan-
gers RePuro allows the introduction
of fresh air at a temperature close to
that of the room concerned, reducing
energy costs that would be incurred
in exchanging the air in traditional
ways or by mechanical ventilation
alone.
Versions available:
• standard (with frost protection for
climates > -10°C)
• R (with electric pre-heater for continuous
operation in cold climates <-10°C; this ver-
sion is not available for sizes 100 and 170)
All units are supplied with the ionizer
filter Cold plasma
Cold plasma is capable of reducing
the level of pollutants, by decompo-
sing the molecules that form them.
Using a series of electric shocks,
"Cold plasma" causes the water mo-
lecules present in the air to separate
into positive and negative ions. The-
se ions neutralise the gas pollutant
molecules, forming products that are
normally present in clean air.
The result is in the air: you can finally
breath clean, odour-free ionised air.
RePuro350R
1. GENERAL WARNINGS
The AERMEC RePuro units are manufactured in
accordance with recognised technical stand-
ards and safety regulations. They are designed
for the renewal and treatment of ambient
air, and they must be used for the purpose
for which they are intended and their perfor-
mance characteristics. All contractual and
extra-contractual liabilities causing damage
to persons, animals or objects or through er-
rors of installation, control or maintenance or
from improper use are excluded by the Com-
pany. Any uses not expressly indicated in this
manual are not permitted.
1.1. CONSERVATION OF DOCUMENTATION
Consign the instructions with all the comple-
mentary documentation to the user of the ac-
cessory who will assume responsibility for the
conservation of the instructions so that these
are always available in case of need.
Carefully read this document. The execution
of all the works must be carried out by quali-
fied personnel, in accordance with the national
regulations. (D.M. 329/2004).
It must be installed in such a way to make
maintenance and/or repair functions possible.
Do not modify or tamper with the accessory
as this may cause danger for which the manu-
facturer will not accept any responsibility for
damages caused. The warranty is voided if the
2. PRODUCT IDENTIFICATION
The RePuro air heat recovery units are identi-
fied through:
− PACKING LABEL
that records the product identification data.
− TECHNICAL LABEL
technical label
above instructions are not followed.
1.2. SAFETY WARNINGS AND INSTALLA-
TION STANDARDS
− The unit must be installed by a competent
and qualified technician, and in accord-
ance with the legislation applicable in the
country of installation (D.M. 329/2004).
AERMEC assumes no responsibility for dam-
age caused by failure to observe these in-
structions.
− Before commencing any works it is neces-
sary to CAREFULLY READ THE INSTRUC-
TIONS AND MINIMISE ANY RISKS BY TAKING
APPROPRIATE SAFETY PRECAUTIONS. All
relevant personnel must be made aware of
the procedures and possible risks that may
arise at the time of installation of the unit
WARNING: The tampering, re-
moval or absence of the identifi-
cation label renders difficult any
operation of installation or main-
tenance.
example of technical label
1811 - 4238020_01
23