AERMEC RePuro 100 Manual De Uso página 35

5.10. SETTING THE PROTECTED PARAMETER "COOLING SETPOINT"
This parameter allows you to set the minimum temperature below which disable any accessory for the management of water coil (if the plenum acces-
sories PLS or PLSM no provision for such an accessory, this parameter will not be considered);
To set the cooling setpoint it is necessary to enter in the password protected menu (as shown in paragraph 11.7), using the navigation keys to run
through the operating parameters until the parameter
use the navigation keys to select the desired value (the accepted range of values is from 8°C to 33°C, default value is 20°C). Then press the MODE/
SELECT key to confirm the selection and exit from the parameter modification mode.
Note: The battery water post-treatment summer, if present, is automatically activated in manual mode, AUX or AUTO as needed.
Season parameter (SPC):
1
2
The appearance of the SET icon shows that the system is awaiting modifi-
cation of the parameter (default cooling setpoint value 20°C)
3
Once the value is confirmed the name of the parameter is again dis-
played.
WARNING: Once in the password protected menu pressing the
navigation keys (
parameters. If during the display of the SEA parameter the (
key is pressed this exits the password menu and to return to the
password menu it is necessary to repeat the procedure detailed
in paragraph 11.7.
SP
is displayed. Press the MODE/SELECT key to enter the parameter modification mode and
c
, ) permits moving between the various
1
2
3
)
Activate parameter modifica-
tion mode
Set the desired cooling setpoint
Confirm the selected value
1811 - 4238020_01
35