AERMEC RePuro 100 Manual De Uso página 41

8.5. AFTER-SALES ASSISTANCE MENU: DIP
Page for displaying the setting, in decimal format, of the dipswitches on the circuit board.
Read only parameter.
8.6. AFTER-SALES ASSISTANCE MENU: INP
Page for displaying the status of the digital inputs on the circuit board.
The status of the digital inputs is shown on the INP page as described in the figure below.
On-> MSF Open
Off-> MSF Closed
On-> CE Open
Off-> CE Closed
On-> CF Open
Off-> CF Closed
8.7. AFTER-SALES ASSISTANCE MENU: FCA
Page for the forced activation of the electric loads in the recovery unit and for the reset of the working hours control of the filters.
To activate the desired load, the operator must set the associated value (see table). The display shows the data set for the entire duration of the forcing
(set by default at 5 seconds). At the end of this time, the FC
coding of the display of the digital inputs
FC
value goes back to zero and the load switches off.
A
On-> JP1 Open
Off-> JP1 Closed
Load activated for 5 seconds
Value
A
1 Fan 1 at maximum speed
2 Fan 2 at maximum speed
3 Reset filter func. hours alarm
4 DMP
5 VSL
6 RXPOST
7 RXPRE
8 LAMP
On-> MSP Open
Off-> MSP Closed
On-> F2 faulty
Off-> F2 ok
On-> F3 faulty
Off-> F3 ok
1811 - 4238020_01
41