AERMEC RePuro 100 Manual De Uso página 24

3. CONTROL PANEL
3.1. WALL MOUNTING THE CONTROL PANEL
The AERMEC RePuro units are controlled by the user through a wired wall mounted control panel. The control panel has an especially low profile design
(12 mm) and can be mounted over a recessed electrical wall box.
The wired control panel has to be connected to the RePuro unit using the cable supplied loose. The cable length supplied is 6 metres long. However, if
a longer cable is required (not provided) then this must have the same characteristics as the cable supplied loose (screened 4 core cable)and must have
a MAXIMUM length of 30 metres.
The functions necessary to install the control panel of the RePuro unit are:
Once the unit is positioned pass the four core cable through the
1
provided aperture up to the wall box (the relationship between
the wall mounted panel and the recessed wall box is shown in the
following paragraph) on top of which the control panel will be
mounted.
Power cable length = 2m
The power cable provided
with the unit is fitted with a
Schuko plug
24
1811 - 4238020_01
WARNING: If this operation requires the removal of the termi-
nal block on the cable from the unit pay particular attention
to the connection sequence of the cables and terminals which
must not be changed.
The wired connecting cable
for the control panel is termi-
nated with a 4 pole terminal
Connecting cable length =
6m
block