AERMEC RePuro 100 Manual De Uso página 30

5.5. SETTING THE SUPPLY FAN SPEED
During manual mode the supply fan speed is activated at the speed set by parameter
speed up to the maximum speed, with 20 intermediate control steps (to match air flow / step, see technical manual).
To set this parameter it is necessary to see the "supply fan menu" (accessed through the procedure detailed in paragraph 11.4), by pressing the key
MODE/SELECT to enter into modification mode (such a mode is shown by the flashing of the fan icon) and entering the desired value using the naviga-
tion keys and confirming the value by pressing the MODE/SELECT key again.
1
Flashing of this icon shows that the modification
mode of the fan speed is active
2
Each press of the navigation keys increases or de-
creases the supply fan speed
3
After having confirmed the value the supply fan operates at the speed set for
this parameter during MANUAL mode operation
30
1811 - 4238020_01
Supply fan menu:
PO
. This parameter can be set varying from the minimum
1
1
Activate fan modification mode
2
Set fan speed
3
Confirm fan speed