AERMEC RePuro 100 Manual De Uso página 29

5.3. ENABLING OF ANY ELECTRIC HEATERS
The RePuro heat recovery unit can be supplied with electric heaters for pre or post heating. These electrical loads can represent a considerable power
input (the power input with electric heaters is specified on the technical nameplate of each unit), hence their activation requires enabling by the user.
To enable the use of the electric heaters in the control logic of the heat recovery unit it is necessary to press the key shown in the diagram (the change from
one mode to the next is the same as shown in paragraph 11.2) until the AUX icon appears on the display.
If this icon is present any electric heaters
provided are ENABLED, but if not present
then the heaters cannot be activated.
WARNING: Enabling the electric heat-
ers is only available during MANUAL
mode.
5.4. NAVIGATION BETWEEN OPERATING MENUS
The settings and the functions available through the control panel are organised in various screens called operating menus. To move between menus
it is necessary to use the navigation keys shown in the diagram below.
Main menu:
Supply fan menu:
Extract fan menu:
Password menu:
If the heat recovery unit is on this key permits the selection
of the operating mode as well as enabling the use of the
electric heaters.
Move to next
menu
Move to
previous menu
29
1811 - 4238020_01