Publicidad
Idiomas disponibles
Idiomas disponibles
Operator's guide:
1. Unpacking instructions
2. Internal cleaning
3. External cleaning
4. Replacing a sliding glass door
5. Connection to the mains
6. Controls
7. Checking correct operation
8. Cleaning the evaporator
9. Replacement of the lamp
! WARNINGS
CAUTION: It is most important that this instruction booklet is kept together with the appliance
both for future reference and for reasons of safety.
1
. Adults should operate this appliance only. Do not allow children to use the controls or play with it. . It
is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical
installation of the appliance should be carried out by a qualified electrician or other competent person.
4. Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
5
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs.
6
7. The manufacturers of this appliance accept no responsibility for the consequences of misuse in
contravention of these safety instructions. It further reserves the right to carry out improvements without
prior notice. 8
. Avoid installing the cabinet directly in line with sunlight. . Never install the appliance near
sources of heat (such as radiators, stoves, etc) and drafts (such as windows, doors, ventilation systems,
air conditioning, etc ...).
air or products to be refrigerated should cause ice to form on the evaporator, we recommend stopping the
compressor and placing the goods in special refrigerated containers, kept at the same temperature, until
defrosting is completed;if this is not carried out the compressor will continue to operate leading to a
wasteful consumption of electricity and poor performance.
refrigeration is off.
!
Our products are for internal use only do not install outside restaurants, shops.
1. UNPACKING INSTRUCTIONS
CARDBOARD BOXES 1a. Cut surrounding tape. Remove the cardboard package by sliding it upwards.
WOODEN CRATE 1b.
between the appliance and pallet or crate.
the appliance on a flat, level surface.
7
it. . Sort out the packaging materials in order to facilitate disposal (see fig. 1).
2. INTERNAL CLEANING (OPTIONAL)
1
. Remove the protective film from the stainless steel trays. . Clean the inside using a soft cloth and
3
neutral detergent. . Dry with a soft cloth.
3. EXTERNAL CLEANING
1
. Use the same products as used for the internal cleaning. . As far as the wooden surfaces are
concerned, use proprietary detergents especially designed for wooden surfaces, which are water-based
and do not contain solvents.
4. REPLACING A SLIDING GLASS DOOR
1.
Lift the door, freeing the bottom part from the lower track.
3.
from the top track.
Replace the door (see figure 4).
5. CONNECTION TO THE MAINS
1
. Ensure that mains voltage and frequency are the same as those stated on the rating plate
2
to the appliance. . Ensure that the supply socket:
rated current as set out on the rating plate;
switch with In = rated value as stated on the rating plate; - differential with Id sensitivity = 30 mA.
3
. Ensure that there is no danger of explosion (AD) in the room. . Make sure the environment is suitable
for the power supply cable provided. The cable of the appliance is H05 VVF, designed for internal use.
5
. Insert the plug in the socket (do not use three-way adapters and reduction adapters).
equipment has been transported or stored overturned, let is rest in its correct position for at least 3 hours
before hooking it up to the mains.
Operator's guide
10
. Keep the ventilation grills free from obstruction for at least 30 cm.
Remove the nails from the wooden crate with care. . Insert forks of forklift truck
3.
Lift the appliance.
6.
Make sure there is nothing left in the package before disposing of
3.
Dry with a clean cloth.
complies with the IEC regulations:- thermal-magnetic
c)
10. Access to the motor compartment
11. Cleaning the stainless steel shelf
Maintenance manual (Page 45):
1. Cleaning the condenser
2. Replacing a glass panel
3. Wiring diagram diagram of refrigeration unit
9
12.
Do not keep the neon light up if the
2
4.
Remove the pallet or crate. . Place
2
2
2.
Pull outwards and lower the door to free it
is properly earthed;
fulfils the requirements of the
a)
b)
4
5
UK
NL
2
3
DK
FIN
11
. If damp
GR
CZ
EE
LV
LT
5
PL
SK
SLO
(A)
attached
N.B.:
if the
I
D
E
F
P
S
B
H
M
Publicidad
