Tecfrigo STYLE VASCA VFS Instalación Y Uso página 6

6. CONTROLS
The controls of the appliance are situated inside a protected recess.
preventing condensation. . Light switch for turning the internal lights on.
I
turning on the refrigeration system. . Thermometer for reading the temperature in the appliance.
Thermostat for adjusting the temperature in the appliance.
UK
temperature set-point, which can be changed by pressing key
D
7. CHECKING CORRECT OPERATION BEFORE USE
CHECK THAT: 1.
E
3. The thermometer shows the desired temperature for the goods to be stored.
5
on. . The door is properly closed.
F 7
lamps. . The room temperature does not exceed that in which the appliance is designed to work
normally, i.e. +30°C, 55% r.h. (climatic class 4).
the motor grille to allow for correct ventilation.
NL
shelves and with sufficient space for cold air circulation.
P
8. CLEANING THE EVAPORATOR (EVERY 15 DAYS)
1.
Switch off the appliance.
S
impair passage of air, complete defrosting should be undertaken
another suitable appliance running at the same temperature. . Leave the door open or defrost
DK
5
completely. . Do not use sharp or pointed metal tools to remove the ice. . Dry with care.
appliance to dry with the door open before restarting.
FIN
9. REPLACEMENT OF THE LAMP
1. Switch off the appliance.
B
the lamp socket, whilst holding the fluorescent tube and its protective cover.
out of the other lamp socket.
GR
above instructions in reverse order (see fig.6).
CZ
10. ACCESS TO THE MOTOR COMPARTMENT
To access the motor compartment, remove the ventilation grilles.
EE
11. CLEANING THE STAINLESS STEEL SHELF
LV
1 . Clean the tank using a soft sponge and neutral detergent. .Turn the tap on to eliminate any residual water.
3. Dry with a soft cloth.
LT
H
M
PL
SK
SLO
Operator's guide
2
4
2.
The plug is connected. The refrigeration unit switch is switched on (green light on).
6.
The appliance is not exposed to direct sunlight or to high-powered
2.
Should the layer of frost be too thick, and ice drips are noted that could
2. Remove the screws securing one of the lamp sockets in place.
5. Replace the fluorescent tube.
1.
Fan switch for turning on the fan
a) Press key
6 "UP" or
8. There is suitable clearance (at least 30 cm) in front of
9.
The cabinet is suitably filled, without overloading the
. 3.
Remove goods and store them in
4
6. Refit all components by following the
2
6
3. Refrigeration switch for
5 "SET or P" to display the
7 "DOWN" (see fig. 2).
4. The internal lights are
6 7.
Leave the
3. Remove
4.
Pull the protective cover