Publicidad
Idiomas disponibles
Idiomas disponibles
1 . Set the age of your child on the RotationControl knob.
2 . Adjust the child car seat to the maximum reclining position and turn it so that it points to the
R1 - 40-75 cm seating position in rear-facing orientation. If your child's height exceeds 75 cm,
please change to the seat position R2 - 76-105 cm.
3 . Press the two lateral Isofi x connector buttons in order to extend the length of the Isofi x con-
nectors.
4 . Guide the Isofi x connectors onto the Isofi x anchor points on the seat of the vehicle and ensure
that they lock into position.
5 . Push the child car seat in until it rests securely against the backrest of the seat of the vehicle.
Ensure that both Isofi x indicators are showing green.
6 . Take the top tether out of the storage compartment and extend it to its full length.
7 . The Top-Tether belt must be threaded through the Top-Tether guide on the side of the child
car seat. Ideally, use the guide towards the interior of your car to ensure rotation to the car
door for easy entry and exit.
8 . Clip the top tether onto the hook provided in your car (e.g. on the back of the car seat or in the
boot. Please consult your car manual for this).
9 . Tighten the top tether until the display on the top tether turns green.
10 . When placing your child in the child car seat, turn the car seat towards the car door for con-
venience.
11 . Unfasten the belt buckle on the child car seat and place the belts on the outside of the seat.
12 . Put your child in the child car seat.
13 . Adjust the height of the headrest as described above.
14 . Fasten the belt buckle again until you hear a click.
15 . Pull the front adjustment strap to tighten the belts. Ensure that the straps are not twisted.
16 . Turn the seat into the rear-facing position. Check that the child car seat is locked in this
position.
- 33 -
EN
Publicidad
