Publicidad
Idiomas disponibles
Idiomas disponibles
1 . The 5-point seat belt and top-tether harness of the child car seat must be stowed as previ-
ously described. These are not needed in this size class.
2 . Press the two lateral Isofi x connector buttons in order to extend the length of the Isofi x con-
nectors.
3 . Guide the Isofi x connectors to the Isofi x anchor points on the car seat and snap them into
place.
4 . Push the child car seat in until it rests securely against the backrest of the car seat. Ensure that
both Isofi x indicators are switched to green.
5 . Thread the diagonal belt of the 3-point seat belt in the car through the diagonal belt guide on
the headrest of the child car seat.
6 . Thread the lap belt of the car's 3-point seat belt through the fi rst lap belt guide in the seat
area of the child car seat.
7 . When placing your child in the child car seat, turn the car seat towards the car door for con-
venience.
8 . Put your child in the child car seat.
9 . Adjust the height of the headrest so that the child's head is fully in the headrest and the diag-
onal belt comes out through the belt guide at the level of the child's shoulders.
10 . Turn the seat into the forward-facing position. Check that the child car seat is locked in this
position.
11 . Close the belt buckle of the 3-point seat belt until you hear a click.
12 . Make sure that both the diagonal belt and the lap belt run through the second lap belt guide
on the child car seat which faces the car's seat belt buckle.
13 . Pull on the diagonal strap to tighten it. Make sure that the straps are not twisted.
14 . The seat position must be set to position 1.
Installation without Isofi x:
Alternatively, the child car seat in the 100-150 cm size class can also be fi tted with the 3-point
seat belt only. Attaching the seat with the Isofi x connectors is not absolutely essential but is
recommended.
- 37 -
EN
Publicidad
