cecotec BOLERO DRESSCODE 7000 D Manual De Instrucciones página 70

ENGLISH
Connection between the washing machine connector and the water supply hose.
1. Align the curved part of the hose and the washer connector (inlet valve) on the back of the
product as shown in figure 7.
2. Tighten the compression nut by turning clockwise.
Connection between a screw tap and the water supply hose
Screw tap and water supply hose.
3. Align the other end of the water supply hose and the threaded tap and tighten the
compression nut tightly by turning clockwise. Check figure 8 for reference.
Drain hose
Note
- Do not kink or protract the drain hose.
- Position the drain hose properly, at 60-90 cm from the floor.
There are two ways to place the end of the drain hose:
- In a drainpipe. It is recommended to use a vertical tube. Fig. 9
- In a sink's drainpipe, over the trap. Fig. 10
If the washing machine has a drain hose bracket (depending on the model), it can also be
installed on a sink or a tank, as indicated next.
Warning
When installing the drain hose, fix it properly with a rope or a clamp. If drain hose is too long,
do not force it into washing machine as it will cause abnormal noises.
4. OPERATION
Note
- Please make sure the appliance is properly installed before operation.
- Before washing the clothes for the first time, the product shall be operated in one round of
the whole procedures without the clothes inside.
- All washing machines are thoroughly checked before leaving the factory and undergo
quality control. There may be a small amount of residual water in the drum. To remove it,
as well as to neutralise possible odours, it is recommended to clean the drum before the
first use. You can run a "Cotton" programme at 90°C without laundry and detergent.
70
BOLERO DRESSCODE 7000 D - 7000 STEEL D