Hyundai N700E Manual De Instrucciones página 90

N700E INSTRUCTION MANUAL
Remark
1. If satisfactory performance through auto-tuning cannot be fully obtained,
please adjust the motor constants for the observed symptoms according to the table below.
Operation
status
When low frequency
(a few Hz) torque is
insufficient.
Powered When the speed
running deviation is negative.
(status with a
accelerating
When the speed
torque)
deviation is positive.
When over current
protection is operated
at injection of load.
Regeneration
When low frequency
(status with a
(a few Hz) torque is
decelerating
insufficient.
torque)
2. If the inverter capacity is more than twice the capacity of the motor in use, the inverter
may not achieve its full performance specifications.
3. When DC braking is enabled, the motor constant will not be accurately set.
Therefore, disable DC braking before starting the auto-tuning procedure.
4. The motor will rotate up to 80% of base frequency : make sure that acceleration or
deceleration is not operated. If then, decrease the manual torque boost setting value.
5. Be sure if motor is in standstill before you carry out an auto-tuning.
Auto-tuning data at the rotating motor status may be the incorrect results.
6. If the auto-tuning procedure is interrupted by the stop command, the auto-tuning constants
may be stored in the inverter. It will be necessary to store the inverters factory defaults setting.
Symptom
Slowly increase the motor constant R1 in relation
to auto-tuning data within 1 to 1.2 times R1.
Slowly increase the rating motor slip H07 in
relation to auto-tuning data within 1.5 times H07
Slowly decrease the rating motor slip H07 in
relation to auto-tuning data within 0.5 times H07
Slowly increase the motor no load current in
relation to auto-tuning data within 1 to 1.2 times.
Slowly increase the motor constant R1 in relation
to auto-tuning data within 1 to 1.2 times R1.
Slowly increase the motor no load current in
relation to auto-tuning data within 1 to 1.2 times.
Decrease the carrier frequency.
Adjustment
5-26
Parameter
H08/H10
H07
H07
H06
H08/H10
H06
b11