Garant XCONTROL 359400 Manual De Instrucciones página 52

GARANT XControl
de
L_LENGTH
bg
da
en
Example
L_LENGTH
fi
L_LENGTH(0.2)
L_LENGTH(1)
fr
L_LENGTH(1.3)
For the specified variables, the values from the following table can be used.
Variable
it
LENGTH MEASUREMENT
hr
FEED RATE
lt
Back to Siemens automated operation [} Page 50]
7.3.5. Auxiliary cycle L_START(1)
nl
Probe cycle
no
L_START(1)
pl
pt
ro
Example
L_START(1)
sv
⁝
L_BREAK
sk
Back to Siemens automated operation [} Page 50]
7.3.6. Auxiliary cycle L_RESET(1)
sl
Probe cycle
es
L_RESET(1)
cs
hu
52
The probe cycle L_LENGTH is for
measuring the tool length of the
tool in the spindle. The tool must
be positioned centrally in the
tool axis with a distance of ap-
prox. 5 mm to the contact point
above the XControl. The two
other axes are not travelled in
the probing process.
Tool length is measured, measured value is in parameter R95.
Tool length is measured, measured value is in parameter R95. Probing speed is 1000 mm/min.
Tool length is measured and overwritten in the tool memory.
Tool length is measured and overwritten in the tool memory. The probing speed is 1500 mm/min.
Value
0
1
0 - 3
Function
XControl switches to standby
mode after 10 minutes without
measurement. Reactivation of
wireless connection is automatic
upon call-up of a probe cycle,
but takes approx. 15 seconds.
Auxiliary cycle L_START(1) can be
used to manually reactivate the
wireless connection, in order to
reduce non-productive times.
Call-up of auxiliary cycle. Start of reactivation.
Tool positioning 5 mm above the XControl
Call-up of the probe cycle (breakage monitoring)
Function
After 100 probe processes, the
wireless connection is deactiv-
ated. The reactivation of the
wireless connection is automatic
upon call-up of a probe cycle and
takes 15 seconds. Through call-
up of the auxiliary cycle, the
With cycle L_LENGTH, it is only
possible to measure the tool
length at the tip.
Note
Note
L_LENGTH(LENGTH MEASURE-
MENT; FEED RATE)
Meaning
Tool length is measured and can be
checked in parameter R95.
Tool length is measured and overwrit-
ten in the tool memory.
Probing feed rate in mm/min
Program code
L_START(1)
Program code
L_RESET(1)