Garant XCONTROL 359400 Manual De Instrucciones página 56

GARANT XControl
de
Probe cycle
bg
BSP_L_LENGTH.H
da
en
fi
Example
0
fr 1
2
3
it
4
5
hr
6
7
lt
8
9
nl
10
11
no
12
For the above-mentioned variables, the values from the following table can be used.
pl
Variable
Q1904
pt
Q1905
ro
Q1913
sv
Example/program code, tool length is measured, measured value is in parameter Q1917.
sk
**Tool length is measured and is overwritten in the tool memory. The probing speed is 1500 mm/min.
0
1
sl
2
3
es
3**
4
cs
5
6
hu
6**
56
Function
BSP_L_LENGTH.H is for measur-
ing the tool length of the tool in
the spindle. The tool must be po-
sitioned centrally in the tool axis
with a distance of approx. 5 mm
to the contact point above the
XControl. The two other axes are
not travelled in the probing pro-
cess.
BEGIN PGM BSP_L_LENGTH MM
;=================================
; 0=MEASURE ONLY / 1=ENTER LENGTH
Q1904 = 0
;=================================
FEED RATE FACTOR;
Q1905 = 1
;=================================
; M19 / M20 SPINDLE ORIENTATION
Q1913 = 19
;=================================
CALL PGM TNC:\X_CONTROL\L_LENGTH.H
END PGM BSP_L_LENGTH MM
Value
0
1
0 - 3
ℤ>0
BEGIN PGM BSP_L_LENGTH MM
;=================================
; 0=MEASURE ONLY / 1=ENTER LENGTH
Q1904 = 0
Q1904 = 1
;=================================
FEED RATE FACTOR;
Q1905 = 1
Q1905 = 3
Note
With the cycle L_LENGTH, it is
only possible to measure the tool
length at the tip.
Program code
BSP_L_LENGTH.H
Meaning
Tool length is measured and is checked
in parameter Q1917.
Tool length is measured and overwrit-
ten in the tool memory.
Factor for the probing speed.
Value for spindle orientation M19 =>
Q1913=19
M20 => Q1913=20