Publicidad
Idiomas disponibles
Idiomas disponibles
MEASURING THE CLEARANCE BY COUNTING TEETH
3. Block the flywheel by using the locking tools (1).
D=Fixing screw
4. Turn the secondary flywheel disc with the lever counter-
clockwise until you can feel the bow springs tensioning.
CAUTION
When turning a double-mass flywheel that is equipped with a
rubbing control plate, you can and may sense an abrupt
mechanical stop. In this case you will have to turn the
secondary flywheel disc with an extra effort for a few
millimeters in both directions over this mechanical stopping
point until you can actually feel the bow springs tensioning.
By doing so, the rubbing control plate will be rotated as well.
5. Release the lever slowly until the springs are unwound
again.
6. Mark the secondary and primary (cranking ring) flywheel
disc abreast.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
