Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING YOUR FURNACE
For your safety, read before
lighting the pilot
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to be
performed (if applicable).
3. Remove control access panel.
4. Push in gas control knob slightly and
turn clockwise to "OFF". Do not Force.
5. Replace control access panel.
IMPORTANT:
KEEP BURNER AND CONTROL COMPARTMENT CLEAN.
WARNING: Due to high surface temperatures, keep
children, clothing, furniture or any combustible material
away from the furnace.
THE FURNACE OPERATES IN THE FOLLOWING
SEQUENCE:
1. Thermostat turns on the main burner.
2. Heat builds up in the furnace and starts the fan (if
equipped). The heated air comes out the front
panel louvers.
3. When the thermostat setting is reached, it shuts off the
main burner.
4. The fan runs until the heat is removed from the furnace,
then it turns off (if equipped).
Your furnace is equipped with a 100% safety pilot that will
shut off the gas supply in case the pilot is not burning
or functioning properly. Make sure the pilot is adjusted
properly and that the pilot generator connection at the
control valve is tight. If the furnace will not stay lit, call your
local gas utility or a qualified service person.
If furnace is equipped with a manual spark igniter, follow
these steps:
1. Review the pilot lighting instructions.
2. When instructed to "Light the Pilot," depress the red
button located on the burner pan for pilot ignition. If
necessary, depress the red button vigorously several
times for pilot ignition.
3. If pilot fails to ignite or a spark is not present while
actuating the red button or by using a match, repeat
steps 5 through 10 listed in "Lighting the Pilot."
24
COZY TOP VENT GRAVITY GAS WALL HEATER
(continued)
WARNING: The surface of the furnace is hot
during operation. Keep children, clothing, furniture,
and flammable material away from it. Keep all access
doors and panels in place except for inspection and
maintenance. On new installations, the gas lines will
be filled with air and it may take several minutes to
establish the pilot flame.
WARNING: Danger of property damage,
bodily injury or death. If the furnace overheats or fails
to shut off, close manual shutoff gas valve to the
furnace before turning off electrical power to the
accessory fan.
WARNING: Protect your eyes against the danger
of ignition flash and eye injury or blindness. Never
attempt to light the pilot with the gas control valve knob
in the "ON" position. Flashback could occur.
How to Care for Your Furnace
WARNING: Danger of bodily injury or death. Turn
off electric power supply at disconnect switch, fuse box
or service panel before removing any doors or access
service panels from unit.
ANNUAL UPKEEP NEEDED
It is recommended that a qualified service technician
perform these maintenance checks at the beginning of
each heating season.
CABINET FINISH
Clean cabinet with damp cloth. Never use abrasive
cleaners. Cabinets are finished with heat resistant powder
paint. Never refinish or paint.
FURNACE AREA
Keep the area near the furnace clear and free from
combustible materials, gasoline and other flammable
liquids and vapors.
COMBUSTION AND VENTILATION AIR
The combustion and ventilation air supply must not be
blocked. Do not put anything in or on the furnace cabinet.
For better circulation and more effective heating, do not
place obstructions, furniture or other items closer than
four&feet in front of the furnace or two&feet from each
side of the furnace.
Publicidad
