Publicidad
Idiomas disponibles
Idiomas disponibles
16
Er-1 Error code
Er-2 Error code
Er-H Error code
Er-5 Error code
Er-6 Error code
Er-7 Error code
LOUISIANA GRILLS
Grill probe is not making a
Check for damage to the grill probe. Follow care and maintenance instructions if
connection
dirty. If all appears in working order, check the connection to the digital control
centre. Unplug unit from power source. Remove hopper access panel (see electric
wire diagram for diagram). Locate the white wires of the grill probe. Disconnect the
spade connectors, then reconnect until it clicks. Replace the hopper access panel.
Grill fails to perform
Check proper positioning of cooking components. Check hopper for sufficient fuel
start-up cycle
or if there is an obstruction in the feed system. Remove pellets and follow care
and maintenance instructions. Check grill probe. Confirm if actual temperature
Grill will not stay lit
is correct and accurate. Follow care and maintenance instructions if dirty. Check
igniter positioning and that it is heating up properly. In extreme cold, the grill may
require a second start. Turn grill off, wait, then turn on again. Check fan. Ensure it is
working properly. Follow care and maintenance instructions if dirty.
The unit has overheated,
Unplug unit from power source and allow to cool. Follow care and maintenance
possibly due to grease fire
instructions. Remove ashes and unburnt pellets from burn grate and bottom of the
or excess fuel
grill. Check burn grate for proper positioning. Check proper positioning of cooking
components. After maintenance, plug unit into power source and press the power
button to turn the unit on. If error code is still displayed, contact Customer Care.
Fan is not making a
Unplug unit from power source. Remove hopper access panel (see electric wire
connection
diagram for diagram). Locate the blue and white wires of the fan. Check fan blades
for damage. Follow care and maintenance instructions if dirty. Disconnect the
spade connectors, then reconnect until it clicks. Replace the hopper access panel.
If error code is still displayed, contact Customer Care.
Igniter is not making a
Unplug unit from power source. Remove hopper access panel (see electric wire
connection
diagram for diagram). Locate the red and white wires of the igniter. Disconnect the
single molex connector, then reconnect until it clicks. Replace the hopper access
panel. If error code is still displayed, contact Customer Care.
Auger motor is not making a
Unplug unit from power source. Remove hopper access panel (see electric wire
connection
diagram for diagram). Locate the yellow and white wires of the auger motor. Check
auger motor and bracket for damage. Disconnect the spade connectors, then
reconnect until it clicks. Replace the hopper access panel. If error code is still
displayed, contact Customer Care.
Publicidad
