JUKI MS-1190/V045 Manual De Instrucciones página 43

17. HOW TO ADJUST THE V045, V046
1
A
B
C
– 10 –
(1) Adjustment of timing between the main body of
sewing machine and the V0 device
1)
Adjust the amount of feed of the main body of sewing
machine to 1.6 mm for the MS-1190/V045 and
MS-1190/V046, and to 2.3 mm for the MS-1190M/V045
and MS-1190M/V046.
Loosen adjusting screw 1 of the V0 device. Set
2)
the adjusting screw at position A (2.0 mm) for the
MS-1190/V045 and MS-1190/V046, and at position B
(2.5 mm) for the MS-1190M/V045 and MS-1190M/
V046. Then, fi x the adjusting screw.
C.
(Caution) In the case urethane roller is used, set the
roller pressure to a lower value than the
set value for the steel roller. An excessive
pressure can deform the urethane roller or
can apply an extra load to the V0 device.