Care And Maintenance; Cleaning Interior/Exterior Components - OHAUS MB35 Manual De Instrucciones

EN-18

5. Care and Maintenance

In this section, you will learn how to keep your Moisture Analyzer in good condition and how to replace expendable
parts.

5.1 Cleaning Interior/Exterior Components

To continue to obtain precise measurements, it is advisable to clean the interior components at regular intervals.
Please note the following instructions for cleaning your instrument.
PROTECTIVE
GLASS
TEMPERATURE
SENSOR
Disconnect the instrument from the power supply before cleaning.
Cleaning Temperature Sensor and Protective Glass
Check the protective glass and the temperature sensor for debris which could
impede the operation. If the glass appears dirty, clean the surface facing the
compartment using a commercial glass cleaner. If the sensor is dirty, clean
using a mild cleaning agent.
Removing Glass for Cleaning
If the inside of the glass is dirty, open the cover and remove the four cover
screws as shown.
Remove the glass holder and glass from the cover and clean with a com-
mercial glass cleaner on both sides.
Reassemble after cleaning.
MB35