Publicidad
Idiomas disponibles
Idiomas disponibles
1-1/2"
(38 mm)
2-11/16"
(68 mm)
1-3/8"
(35 mm)
2-3/8"
(60 mm)
Roughing-In
Before You Begin
NOTICE: Do not install the valve under a whirlpool surround or any location where the temperature may
exceed 104°F (40°C). The valve and its integrated power supply is rated to operate in temperatures up to
104°F (40°C).
NOTICE: Do not apply excessive heat near the valve or apply flux or acids directly onto the valve. This
valve contains plastic and rubber components which will melt if heat is directly applied.
NOTICE: Do not apply petroleum-based lubricants to the valve components. Doing so will damage the
valve components.
NOTICE: Do not use oil-based, non-setting compounds, such as plumbers putty, on the threaded
connections.
NOTICE: Do not remove the check valves from the inlets as this can damage the product.
NOTICE: If the valve will be used for a bath/shower application, the bath fill supply line must be routed
from the #1 outlet port.
Read these instructions and determine the locations of all required components before beginning
installation.
For optimum performance, 1/2" dedicated water supply lines are recommended.
When possible, install the valve before installing the interface(s).
If possible, flush all piping thoroughly before installing the valve. If the pipes are flushed after the
valve is installed, clean the inlet screens before using the system.
1217542-2-B
12" (305 mm)
15-1/8" (384 mm)
2"
1-13/16
(51 mm)
2-3/8"
(46 mm)
(60 mm)
12-1/2"
(318 mm)
9-1/2"
(241 mm)
1"
(25 mm)
4
3-3/8"
(86 mm)
8-1/16" (205 mm)
3/4"
(19 mm)
10-5/16" (262 mm)
11-5/8" (295 mm)
13-3/8" (340 mm)
1-5/16"
(33 mm)
Kohler Co.
Publicidad
