Descargar Imprimir esta página

Medline Hemo-Force MDS600INT2 Instrucciones De Operación página 11

Bomba para tvp intermitente 2nda generación
Ocultar thumbs Ver también para Hemo-Force MDS600INT2:

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating Instructions (cont)
5.
Application of the Foot garment(s).
a) Foot garments come in identical pairs and
may be used on either foot.
b) Place the garment on the patient's foot ensuring
the hook and loop attachments are visible.
c)
Ensure a snug fit by placing two fingers around the back of
the garment to ensure the garment is not too tight. Routinely
inspect the patient's feet once compression commences.
d) Using the same procedures, apply the
second model garment if needed.
e) If only one garment is to be used simply leave the unused
air outlet on the pump free (no garment attached).
6. Air hose(s) are required to connect the garment(s) to the pump
and are provided separately. Attach the garment(s) to the
air hose(s) using the connectors. Each tube has a male-end
connector at one end and a female connector at the other.
The female end will fit the male end on the garment.
7.
Attach the other end(s) of the air hose(s) (male end) to the
female connector(s) on the pump. If you need to disconnect
the tubing, pull on the connector to disconnect.
8. Press and hold the power button to turn the pump on when
the air hose(s) and the garment(s) are properly connected.
9.
The pump will automatically detect single/dual and leg (calf/
thigh)/foot models of garment(s) during the initialization process
lasting approximately 10 seconds. Highlighted graphics will
display how many feet versus leg garments are attached.
10. After initialization, check to confirm the screen
graphic(s) displays the desired settings.
11. To activate the timer, turn the pump on and timing will commence.
The timer will reflect minutes of compression. When compression is
interrupted and the pump is turned off, the timer will suspend timing
until the patient is reconnected to therapy and therapy is continued.
12. To reset the timer press "TIMER RESET" for
5 seconds and it will reset itself.
13. To turn the pump off, hold the POWER button for 1 second.
14. To disconnect the device, remove the plug from the electrical outlet.
15. To remove the garments, pull the connectors apart.
11

Publicidad

loading