Publicidad
Idiomas disponibles
Idiomas disponibles
• If the supply cord becomes damaged, it must be replaced by the manufacturer, its
service
agent or similarly qualified persons in order to avoid a danger or injury.
• The appliance is not intended to be operated by means of an external timer or
separated remote control system.
• The appliance is for domestic use only and only for cooking food. Do not use this
appliance as a source of heat.
• The manufacturer declines all liability for personal or material damage as a result of
misuse or incorrect installation of this appliance.
• Danger of burns! During use the appliance becomes hot. Care should be taken to
avoid touching heating elements inside the oven.
• Do not lean on the door or place any objects on the door of the appliance. This can
damage the door hinges.
• The oven must be installed in accordance with installation instructions and all
dimensions must be followed.
• Before connecting the appliance to the power supply, check that the power supply
voltage and current rating corresponds with the power supply details shown on the
appliance rating label.
• Never use a damaged appliance! Disconnect the appliance from the electrical outlet
and con- tact your retailer if it is damaged.
• Danger of electric shock! Do not attempt to repair the appliance yourself. In case of
malfunc- tion, repairs are to be conducted by qualified personnel only.
• To avoid damaging the cord, do not squeeze, bend or chafe it on sharp edges. Keep it
away from hot surfaces and open flames.
• Lay out the cord in such a way that no unintentional pulling or tripping over it is
possible. Keep the appliance and its cord out of reach of children.Do not operate the
appliance with wet hands or while standing on a wet floor.Always turn the appliance off
before disconnecting it from the power supply.
• Disconnect the oven from the power supply when not in use and before cleaning.
• Warning: This appliance is supplied with a three core supply cord and must be
connected direct to the mains electricity supply via a omnipolar or double pole switch
having a 3mm minimum contact gap on each connector.
• The fused spur should be installed in an easily reachable place so that in case of
emergency the appliance can be disconnected from power immediately.
• The fixed wiring must be protected against heat surfaces.
• Do not hang any objects on the handle of the oven door.
• Caution: Do not cover the bottom of the oven with aluminium foil or other objects.
There is a risk of fire and damage to the enamel in the oven!
• Do not allow aluminium foil, plastic, paper or fabric contact with heating elements.
Never leave the appliance unattended during use, especially when cooking with
flammable substances (e.g. hot oil, fat, etc.).
• Do not store or never use harsh chemicals, sprays, flammable or nonfood in or near
the oven.
• This oven is designed specifically for heating or cooking food. The use of corrosive
chemicals in heating or cleaning will damage the unit and may cause injury.
EN-3
Publicidad
