Descargar Imprimir esta página

Cata CMD 9208 BK Instrucciones De Uso Y Mantenimiento página 31

Publicidad

Idiomas disponibles

Idiomas disponibles

Removing and Cleaning the oven door
The oven door is equipped with three glass panels. You can remove the oven door and the internal glass
panels to clean them.
The oven door could close again if you try to remove the glass panels before taking off the oven door.
CAUTION!
Refer to the chapters on safety.
REMOVING THE OVEN DOOR
1. Open the oven door completely
2. Position the hooks "A" of the hinges outwards (Fig.7)
3. Slowly close the door to reach the hooks "A", making sure that they lock in the slots "B" of the door, as
shown in Fig.8
4. Using both hands, press lightly inwards on the door, allowing the door hinges "C" to detach from the slots
"D" (see Fig.9), and pull the door towards yourself until it has unhooked from the oven.
5. After cleaning, fit the door back on properly by following the procedure in reverse order. Reposition the
hooks "A" inwards before closing the door (Fig.10)
A
Fig. 7
CLEANING THE OVEN DOOR
After removing the oven door from the framework, place it on a surface with the inner glass (double
glazing) facing towards yourself (Figure 3)
Remove the double glazing carefully by raising it approximately 25 degrees (Figure 4) until the retaining
springs unhook
Push the double glazing in the direction of the arrow (Figure 5) and pull it completely out in order to
proceed with cleaning. At this point you can also remove the middle glazing in the oven door (follow the
procedure of Figure 6) and proceed with cleaning.
When cleaning is completed, fit the parts back on by following the reverse procedure to that described
above to put the oven door back into its original condition.
A
B
A A
Fig. 8
Fig. 3
Fig. 5
EN-13
C
D
Fig. 9
Fig. 4
Glass
Rubber
Fig. 10
Fig. 6
A

Publicidad

loading