Makita DCG180 Manual De Instrucciones página 10

OPERATION
CAUTION:
Do not use solid caulking material.
Be sure to remove the solid caulking material
before the installation. Solid caulking material may
cause malfunction or personal injury.
NOTICE:
Make sure the attachment parts are
correct by referring the section for the parts
preparation. Using improper parts may cause leak-
age or tool breakage.
NOTICE:
Always keep the rod and piston clean.
Adhered caulk may damage the tool.
Using cartridge
Preparing cartridge for use
1.
Cut the tip of the cartridge nozzle so that the
suitable amount of caulking material which you want to
feed.
1
Fig.12
► 1. Nozzle
2. Make a hole on the protective film with the tip of
the nozzle.
1
Fig.13
► 1. Nozzle
3.
Attach the nozzle to the cartridge.
NOTICE:
Be sure to check the cartridge for
damage before installation. Using the damaged
cartridge may cause malfunction.
Installing cartridge to holder A
1. Pull the rod handle backward slowly until it stops.
Fig.14
► 1. Rod handle
2. Insert the cartridge into the holder as shown in the
figure.
Fig.15
3. Push the rod gently until the piston touches the
bottom of cartridge.
To remove the cartridge, pull the rod backwards until it
stops, then lift out the cartridge.
Installing cartridge to other than
holder A
1. Pull the rod handle backward slowly until it stops.
Fig.16
► 1. Rod handle
2.
Insert the cartridge into the holder.
10 ENGLISH
1
1