Makita DCG180 Manual De Instrucciones página 11

3. Attach the holder joint (as a cap) by turning it
firmly while holding the holder.
3
Fig.17
► 1. Holder 2. Cartridge 3. Holder joint (as a cap)
4.
Push the rod gently until the piston touches the
bottom of cartridge.
To remove the cartridge, follow the installation procedure in reverse.
Using film type package
Preparing package for use
Cut off the tip of the package.
Fig.18
NOTICE:
Be sure to check the package for dam-
age before installation. Using the damaged pack-
age may cause malfunction.
Installing film type package to holder
1. Pull the rod handle backward slowly until it stops.
Fig.19
► 1. Rod handle
2 1
1
2. Insert the package into the holder.
3. Attach the rubber ring, nozzle, and holder joint (as
a cap). Fasten the holder joint (as a cap) firmly.
5 4
Fig.20
► 1. Holder 2. Film package 3. Rubber ring 4. Nozzle
5. Holder joint (as a cap)
4. Push the rod gently until the piston touches the package.
To remove the package, remove the holder joint (as a cap), nozzle,
rubber ring, and then push the rod handle forward until it stops.
Direct filling
1. Push the rod handle all the way until it stops.
Fig.21
► 1. Rod handle
2. Insert the tip of the holder into the caulking material, and then
pull the rod handle slowly to fill the holder with the caulking material.
1
Fig.22
► 1. Holder
11 ENGLISH
2 1
3
1