Makita DCG180 Manual De Instrucciones página 9

Direct filling
- 300 ml 400 ml
(10 fl oz) (14 fl oz)
(Not
available)
Holder -
joint
Plate -
Rod -
Short rod
Piston -
Holder -
Holder D
Rubber -
ring
Rubber ring for holder
Nozzle -
Nozzle for holder joint B
Holder -
joint
(as a
cap)
Installing or removing the holder
joint
Attach the holder joint and plate by securing the screws
firmly. To remove the holder joint, follow the installation
procedure in reverse.
1 2
Fig.8
► 1. Screw 2. Plate 3. Holder joint
600 ml 800 ml
(20 fl oz) (29 fl oz)
(Not
available)
-
Holder joint B
-
Plate
-
Long rod
-
Piston C
-
Holder B
-
joint B
-
-
Holder joint B
3
Installing or removing the rod and piston
1. Insert the rod from the rear side of the tool with its
teeth facing down.
1
Fig.9
► 1. Rod
2.
Attach piston to the screw.
1 2 3
Fig.10
► 1. Screw 2. Piston 3. Rod
To remove the rod and piston, follow the installation
procedure in reverse.
Installing or removing the holder
CAUTION:
Secure the holder to the holder
joint firmly. Otherwise the holder may come off
during operation and may cause an injury.
To install the holder, turn it clockwise firmly until it stops
while holding the holder joint. To remove the holder,
follow the installation procedure in reverse.
Fig.11
► 1. Holder 2. Holder joint
9 ENGLISH
1 2