ENOW00014-0
CAUTION
Make sure that the battery leads do not
get stuck between the outboard motor
and boat when turning, etc.
The starter motor may fail to operate if
the leads are incorrectly connected.
Be sure to correctly connect the (+) and
(—) leads. If not, the charging system will
be damaged.
Do not disconnect the battery leads from
battery while the engine is operating, the
electrical parts could be damaged.
Always use a fully charged battery.
ENOW00015-0
CAUTION
Do not use a batter y that is not recom-
mended. Use of a battery not recommended
can lead to poor performance of, and/or
damage to, the electrical system.
ENON00006-A
Note
Recommended battery: 12V 70Ah/5HR,
650 (Cold Cranking Amps (CCA), In case of
cold whether: 12V100Ah/5HR (850CCA))
Specifications and features of batteries
vary among the manufacturers. Consult
the manufacturer for details.
* The battery should be purchased sepa-
rately and is not supplied with the out-
board motor.
1. Place the battery box in a convenient
position away from possible water
spray. Securely fasten both the box
and the battery so they do not shake
loose.
2. Connect the positive lead (+) to the
positive terminal (+) of the battery,
and then connect the negative lead
(—). When disconnecting the battery
always remove the negative lead (—)
first. After connecting the positive
terminal (+), securely place a cap on
it to prevent short circuits.
1
1. Battery cord (red)
2. Battery cord (black)
ENOM00971-0
4. TOCS (Tohatsu Onboard
Communication System)
installation
TOCS (Tohatsu Onboard Communication
System) interface coupler can provide
information regarding engine speed,
fuel consumption, and various malfunc-
tion via an optional interface cable.
Contact authorized Tohatsu dealer for
more detail.
27
INSTALLATION
5
2
ENOF00022-0
ENOF01146-0