Maxeon SunPower Reserve Instrucciones De Instalación página 48

3.
PH2x150mm
1.0mm
TIP
3. Install the left cable cover of the inverter
Install the snap of
the plastic part on
the upper cover
TIP
© 2023 Maxeon Solar Technologies, Ltd. All rights reserved. | 547143 Revision B - June 2023
Specifications included in this document are subject to change without notice
The serial number and check code of the inverter is located on right side
of the inverter. Make sure that you have made a note of them before
installing this cover.
1
Install the three snaps of
the plastic parts into the
corresponding holes
2
Make sure all the wiring is secure and the system is working properly and
then install the top cover on the left side of the inverter.
4.
Put the locating
pin into the holes
3
47