True Spec Serie Manual De Instalación página 16

Appliance Operation
Appliance Operation
WARNING – SPOILAGE!
The owner is solely responsible for
ensuring safe holding temperature
levels for all food items. Failure to do so
may result in unsafe food products. Loss or spoilage
of products in your appliance is not covered by
warranty. In addition to following recommended
installation procedures, run the appliance for 24 hours
prior to usage to verify operation.
Startup
USER ACTION!
Before loading product, run your TRUE appliance
empty for 24 hours to verify proper operation.
Remember, our factory warranty
product loss!
• The compressor is ready to operate when the appliance is
purchased. All you need to do is plug in the cooler.
• Good air flow inside your TRUE appliance is critical. Take care
to prevent product from pressing against the sides or back
wall and coming within 4" (101.6 mm) of the evaporator
housing. Refrigerated air must circulate throughout the
appliance for even product temperatures.
• Excessive tampering with the control could lead to service
difficulties. If replacing the temperature control is ever
needed, be sure to order the replacement from your TRUE
dealer or recommended service agent.
• All covers and access panels must be in place and properly
secured before operating this appliance.
• If the appliance has rested on its back or side, be sure to leave
the appliance upright twice the time it was laying down (up
to four (4) hours) before restoring power. If this time exceeds
four (4) hours, let the appliance stand upright for 24 hours
before powering the unit.
Page 16 of 240
QUICK START MANUAL
Light Switch Location
The light symbol
switch.
DOES NOT
cover
Fig. 1. Example of light symbol and light switch location.
08/3/2023
shows the approximate location of the light
P#844594 TEC_TM_169 | REV. B | ALL
truemfg.com