MRA 4025066163793 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA-Screen
4 Rubber washers 16x10x2mm
1 Protective edge strip, clamping
sleeves
Fitting the screen to the motorcycle:
Place the motorcycle on a flat surface.
1.
Disassemble the two mirrors and the motorcycle windshield.
2.
Place a rubber ring [11357] on each screw fastening of the mirror mounts.
3.
Then tighten the MRA washer and mirrors with the original screws.
4.
Fit the protective edge strip onto the screen. Cut off the rest if required.
5.
Push the clamping sleeves over the ends of the protective edge strip and
6.
lightly compress these using a pair of pliers to secure the edge strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Kawasaki Ninja 250/400 2018-
Article No..
--- Allen key 4mm
11357
---
3
Required tools