Corghi EM 9250 CompactLine Manual De Uso página 101

- Pulling the pin as shown in the fig. 10c so screw the C hub manually until it reaches the
end position.
- Tighten the C hub by inserting the C special wrench into the C hub hole
- Remove the cotter pin from the cylindrical protective sleeve inserted previously.
- To adequately tighten the hub must be given a hammer blow on the special key C (you
can also use the pliers, hammer side, to fix the spring-loaded weights).
If during the assembly phase the hub C should freeze before completing the tightening
phase, proceed as follows:
- Make a complete turn in the opposite direction of the hub C
- Remove the split pin B
- Push the hub C in the direction shown in figure 10e and then tighten the hub until it stops.
IMPORTANT
During the tightening phase, check that the ratchets are always closed inside the locking
sleeve.
EM 9250 - EM 9250 C CompactLine Operator's manual
10c
(fig.10d).
10d
10e
UK
101