Switching On The Machine; Using The Automatic Wheel Clamping System C - Corghi EM 9250 CompactLine Manual De Uso

1. SWITCHING ON THE MACHINE

Connect the power supply cable (A, Fig.10) sup-
plied with the machine from the external electrical
panel located on the rear side of the wheel balancer
body to the mains.
Switch on the machine using the switch on the rear
side of the body (B, Fig.10).
The wheel balancer performs a checking test (all
the LEDs illuminate), and if no faults are detected,
a beeper sounds and the cycle status initially ac-
tive is displayed, as follows:
- active balancing mode: dynamic (dyn);
- values displayed: 000 000;
- grams displayed in units of 5 (or 1/4 of an ounce);
- active sensor rounding-off (version with digital
sensor);
- default geometric values: width = 5.5", diameter = 14", distance = 150 mm.
Now the operator can set the data of the wheel to be balanced or select one of the pro-
grammes available.
1.1. USING THE AUTOMATIC WHEEL
Wheel locking procedure with the automatic system C
Centring with cone at front
- Fit the wheel on the shaft, sliding it into place until it rests against the flange.
- Fit the most suitable cone on the shaft and insert it into the central hole of the wheel.
- Fit the locking device by making it slide on the hub until it comes into contact with the
cone.
- Press the control pedal for at least one
Centring with cone at rear
- Fit the most suitable cone for the central hole of the wheel on the shaft.
- Fit the wheel onto the cone, sliding it into place until the cone comes into contact with
the plate that holds the spring.
- Apply the protective cap to the sleeve.
- Fit the locking device by making it slide on the hub until it comes into contact with the
wheel.
- Press the control pedal for at least one
EM 9250 - EM 9250 C CompactLine Operator's manual
CLAMPING SYSTEM C
second.
second.
10
UK
99