Publicidad
Idiomas disponibles
Idiomas disponibles
3 YEARS
L I M I T E D WA R R A N T Y
Switch operation:
Before turning on the tool, check that the switch is working properly and in the "O" (o ) state.
To start the tool, push the switch to "I" (on) The location starts. To stop the tool, simply turn the
switch on The "O" (close) position tool stops.
Operation:
Please hold the tool, start the tool and wait for it to get maximum speed, and then slowly place
the tool on the surface of the work piece. When using a sanding machine, only a small amount of
objects area usually removed at one time.
Because the mass of the surface is more important than the weight of the object. Don't press
hard on the tool. Throughout the operation Please keep the oor level with the work piece.
Excessive pressure will Damage sandpaper and shorten life. If you put a piece of cloth under the
tool, you can stay at home Provides or other ne surfaces with high nish.
Attention: Do not block the motor inlet with your ngers or palm. Never open tool work without
sandpaper, or will seriously damage the liner. This tool is not waterproof, so the workpiece Do not
use water on the surface.
Replace the carbon brush:
Unplug the power plug before installing or removing the carbon brush. Use one - word screwdri-
ver to loosen the opening spring pressure position of the carbon brush on the brush holder. Then
tilt the body to slide the brush out and use the tongs to hold the brush Pull out, change the
brush, put it back in place, then use the tray Spring pressure.
6
Publicidad
