Parameter Configuration - RCM GO Serie Manual De Uso Y Mantenimiento

Confi guration of the battery type (machines with drive system)
If one wishes to fi t the machine with "LEAD-ACID and/or GEL" batteries, one can change the parameters relating to the type of battery, by procee-
ding as follows:
Upon start-up, during the display of the machine model and software, press and hold the suction button and simultaneously press the brushes
button four times, in order to access the "PARAMETERS MANAGEMENT" menu.
1- PARAMETERS
2- DISPLAYCONTRAST* (selectable with the brushes button) - the value is increased with the suction button and decreased with the brush button
- the value is confi rmed after pressing the brush and suction buttons simultaneously.
By pressing the suction button one accesses the parameter modifi cation menu:
1- STANDARD PARAMETERS
2- ADVANCED PARAMETERS (IMPORTANT NOTE: these parameters must not be changed, contact the technical assistance service if needed)
STANDARD PARAMETERS (selectable with the suction button)
scroll the parameters with the brushes button (=increase) and/or the suction button (=decrease)
To change the parameter press the "suction and brushes" buttons simultaneously, subsequently to change the value press the brushes button
(=increase) and/or the suction button (=decrease).
To confi rm the chosen value press the "brushes and suction" buttons simultaneously.
1°
Parameter - Type of battery "TipoBatt"
Default: 1(Pb) for Lead-Acid batteries;
0(Gel) for Gel batteries.
2° (Do not change this parameter and contact technical assistance service)
Parameter - "OFFTime" Time for water electrovalve and subsequently brush motor shutdown.
Default: 20
Min: 1
Max: 99
Unit of Measure: sec/10
2° (Do not change this parameter and contact technical assistance service)
Parameter - "OFFTime" Delay time between suction function deactivation and actual suction motor shutdown.
Default: 30
Min: 0
Max: 999
Unit of Measure: sec/10

PARAMETER CONFIGURATION

52