Setting The Dipswitches On The Battery Charger; Routine Checking And Maintenance Operations - RCM GO Serie Manual De Uso Y Mantenimiento

Setting the dipswitches 6 on the battery charger - CBHF1-SM 24V 12A
(See Fig.13)
In the following tables you can fi nd meaning of all diff erent position of dipswitch for programming CBHF1-SM 24V 12A. battery charger.
DIP 1, DIP 2, DIP 3, DIP 4 for the selection of the CHARGING CURVE.
DIP 5, DIP 6, DIP 7 for the selection of the CURRENT 11.
DIP 8, for the selection of the battery voltage.
Dip 1 Dip 2 Dip 3
ON ON ON
>OFF ON ON
ON OFF ON
OFF OFF ON
ON ON OFF
OFF ON OFF
>ON OFF OFF
OFF OFF OFF
ON ON ON
OFF ON ON
ON OFF ON
>OFF OFF ON
ON ON OFF
OFF ON OFF
ON OFF OFF
OFF OFF OFF
Dip 5 Dip 6 Dip 7
ON ON ON
OFF ON ON
ON OFF ON
OFF OFF ON

ROUTINE CHECKING AND MAINTENANCE OPERATIONS

!
Caution!
For any maintenance, overhaul or repair, use specialist staff or contact an authorised service centre.
Checking and maintenance operations table
1 Check on battery liquid
2 Check wear of vacuum motor shoes
3 Check brush motor shoes
4 Check brush drive motor (GO with drive system)
5 Check and clean drive motor (GO with drive system)
6 Clean recovery tank fi lter
7 Remove deposits and dirt from the liquid residue drain line
8 Check that the contact edges of the squeegee rubber strips are intact; otherwise replace them
9 Check the tension of the brush drive belt (for two-brush machines)
Dip 4 Charging curve
ON 0
ON 1 (Curve for LEAD-ACID [Wet] traction batteries)
ON 2
ON 3
ON 4
ON 5
ON 6 (Curve for AGM and GEL batteries and other manufacturers)
ON 7
OFF 8
OFF 9
OFF 10
OFF 11 (Curve for GEL batteries from SONNENSCHEIN, DETA and other manufacturers)
OFF 12
OFF 13
OFF 14
OFF 15
CURRENT
Dip 8
4A ON
8A OFF
10A
12A
56
VB
12
24
To be carried out every hours...
8 40 150 500
√
√
√
√
√
√
√
√
√