JAROLIFT TDEF Serie Instrucciones Originales página 37

Teaching in the hand and wall transmitters
(initial programming)
1. Connect the motor in accordance with the installation
instructions (see page 35).
2. Press the programming button on the motor head brief-
ly. The motor (roller shutter) vibrates briefly. The receiver in
the motor is now ready to learn for approx. 5 seconds.
3. Within these approx. 5 seconds, press the UP and DOWN
buttons at the same time and then immediately press the
STOP button of your transmitter.
4. The motor (roller shutter) vibrates again. The code has
been successfully taught in.
Programming button
SETTINGS
Then check the function
with the UP / STOP / DOWN
buttons.
The direction of rotation of
the motor depends on the
installation position (left/
right) as well as the winding
direction of the roller shut-
ter (left roller /right roller).
If the motor (roller shutter)
moves in the downward di-
rection when the UP button
is pressed, the direction of
rotation of the motor must
be changed.
Please refer to the chapter
"Changing the direction of
rotation of the motor" (next
page).
37