JAROLIFT TDEF Serie Instrucciones Originales página 38

SETTINGS
Changing the direction of rotation of the motor
Option A
1. Press the programming button on the motor head for approx. 3 seconds.
The motor will vibrate briefly.
The direction of rotation of the motor has changed.
Option B
(if the programming button on the motor cannot be accessed).
ATTENTION!
If several motors are connected to the same fuse, it is imperative to observe this note!
Disconnecting and reconnecting the power supply (fuse OFF/ON) makes ALL motors
connected to this fuse ready to learn! For this reason, the motors must be disconnect-
ed from the electricity supply by disconnecting the supply line if necessary, in order to
avoid unintentionally re-teaching the hand transmitter to other motors! Observe the
regulations for electrical connection (page 35)!
1. Press the UP and DOWN button on your taught-in transmitter at the same time.
2. Then press the STOP button 6x.
3. Press the UP button after the STOP button.
4. Now disconnect the motor from the power supply (fuse off ), wait approx. 10 se-
conds, and switch the power supply back on.
UP and DOWN
The receiver in the motor is now ready to learn for approx. 5 seconds.
For further programming steps, see the next page
38
Programming button
6 x STOP UP Current OFF
min.
10 sec.
Current ON