JAROLIFT TDEF Serie Instrucciones Originales página 39

5. Within these approx. 5 seconds, press the UP and DOWN button at the same
time and then immediately press the STOP button of your transmitter.
Be sure that only the
corresponding motor
is ready to learn!
6. The motor vibrates briefly, the transmitter has been taught in again. The direction of rotation of the
motor has changed.
Setting the end points / end positions
First set the lower end point.
1. Move the roller shutter shaft (without curtain) to a posi-
tion that allows you to fasten the steel strip hangers in the
hanging openings of the shaft.
To do this, press the DOWN button on your transmitter and
observe the rotation of the shaft.
As soon as the shaft has reached the necessary position for
hanging the steel strip hangers, press the STOP button.
2. Hang the curtain with the steel strip hangers onto the
shaft.
3. Correct the lower end point with the UP/DOWN and STOP
buttons if necessary.
4. Press the UP and DOWN buttons on the transmitter at the
same time.
5. Then press the STOP button 2x.
6. Press the DOWN button briefly within 10 seconds.
The motor will confirm the setting of the lower end point
by vibrating briefly.
UP and DOWN
UP and DOWN
2 x STOP 1 x DOWN
STOP
SETTINGS
39