GUTMANN Rayo Instrucciones De Montaje página 13

2. Mark the positions for the following
fixing holes according to the indicated
dimensions. Dimensions which are not
indicated depend on the model and
must be Masuren on the hood. Ensure
that there is a minimum distance be-
tween the hotplate and lower edge of
the extractor hood.
2 holes (6 mm) for attachment of the
upper tower
2 holes (10 mm) for attachment of the
extractor hood.
3. Drill the holes and insert the corre-
sponding wall plugs flush with the wall:
4. Attach the bracket for the upper tower.
5. Screw woodtometal dowel screws
into the wall plugs (10 mm holes), leav-
ing them projecting by 20 mm.
6. Attach the extractor hood and loosely
screw on the washers and nuts.
7. (For models with a glass panel) fold
down the glass panel. Pull the glass
panel slightly forwards until it can be
folded down a little. Press back the
glass panel in this inclined Position until
it is released. Then fold down the glass
panel all the way.
8. (Only for hoods with a glass panel)
fold up the glass panel in the reverse
sequence.
Ø 11 HGH
en
13