Publicidad
Idiomas disponibles
Idiomas disponibles
3. Open the lock-off device and insert the shoulder belt portion of the vehicle
8
belt through it.
4. While pressing the child restraint, into the vehicle seat cushion pull the
belts to fasten the child restraint tightly and securely.
!
The child restraint can not be used if the vehicle safety belt buckle (female
buckle end) is too long to anchor the child restraint securely.
!
Please check a correct installation by moving the child restraint back and
forth.
A correct installed seat (vehicle belt path) is shown in
!
Shoulder belt passes through Lock-off Device, as
!
Waist belt passes through the back slot, as
!
The vehicle buckle tongue is engaged with vehicle female buckle end as
10
-3
ii. Securing your Child in the Child Restraint
1. While pressing the harness adjustment button, pull the shoulder harnesses
completely of the child restraint.
2. P ress the red button to disengage the buckle.
3. P lace the child in the child restraint and engage the buckle.
4. P ull down the adjustment webbing and adjust it to the proper length so
that your child is snugly secured.
!
After the child is seated, recheck whether the shoulder harnesses are at
proper height.
!
Make sure that the shoulder harnesses fit snugly against the shoulders of
the child (no belt slack).
Booster Mode
(
Child height 100cm-145cm/Child weight 36kg/
3.5 - 12 years old)
see images
-
15
19
i. Installation
!
Just use the vehicle seat belt when installing the child restraint in the
booster mode, do no longer the internal harness system. Please store the
15
9
10
10
-1
10
-2
11
12
13
14
shoulder straps, buckle and buckle tongues in respective storage
17
compartments as shown in
.
!
Please adjust the shoulder harnesses to proper length before store the
shoulder straps and buckle in their storage compartments.
!
Please adjust the child restraint to proper angle.
!
When installing and adjusting the safety belts, make sure that both the
shoulder belt and the waist belt are not twisted and will not keep the
safety belts from being properly positioned.
1. Press the red button to disengage the buckle.
2. Remove the crotch strap.
16
3. Detach the snaps.
17
-1
4. Lift the upper flap upward and pull the lower flap forward, and then store
the shoulder straps in their storage compartments.
5. Pull the buckle to the back of the seat pad, and then store the buckle and
buckle tongues in respective storage compartments.
6. Do reattach the snaps to recover the seat pad. The recovered seat pad is
shown as
18
ii. Securing your Child in the Child Restraint
1. Let the child sit in the child restraint, check whether the shoulder belt
guides are at proper height.
2. Position shoulder belt through shoulder belt guide, pass waist belt through
seat slots. Fasten buckle and pull the vehicle belt to tighten.
!
Shoulder belt must pass through shoulder belt guide as shown in
!
Waist belt must pass through seat slots.
!
The child restraint can not be used if the vehicle safety belt buckle (female
buckle end) is too long to anchor the child restraint securely.
!
Never use a vehicle waist-only belt to secure your child.
!
Do not use shoulder belt loose or positioned under arm.
!
Do not use shoulder belt behind child's back.
!
Do not allow child to slide down in the child restraint in case of
strangulation.
15
17
-2
&
17
-3
17
-4
19
19
-1.
16
Publicidad
